1. Maxi-Flo Swimming pool heat exchanger suitable for a small
temperature difference, the small resistance to heat transfer
requirements, are dedicated to swimming pool heat exchanger,
therefore selection of the design should pay special attention to
the following 3 points: 1). Circulation flow rate by 25% through the single-tube heat
exchanger when the pressure drop is less than 0.5Mpa type design. 2). By Qa calculation for a single heat exchanger heat transfer
area. 3). Election with the type of heat exchanger 2, the initial heating
of pool water at the same time when the 2 running, water run-time
of normal insulation, heat-for example by only one on the list, but
in order to reduce the resistance should be 2 running at the same
time, this can be so that the pressure drop reduced to 0.25Mpa the
following in order to choose low-lift swimming pool pump, water
treatment systems to achieve energy efficient operation. 2. Maxi-Flo Heat exchanger has automatic descaling function of
fluid pressure drop is also small, but their prices more expensive
plate heat exchanger, installation required a larger space, the
current application in the pool less. 3. Maxi-Flo Heat exchangers for industrial products of its heat
transfer coefficient for traditional heat exchanger tube 2-3 times
the flow resistance in small and difficult to scaling, automatic
compensation function of thermal stress.